Forgot password?

Create an account!

Forum

« back

RhinoScript – Problem creating surfaces

Messages

Please log in to write a message.

  • 3. xavido (Aug 30, 2010 10.30):

    Works fine!

    I miss a lot of information about rhinoscript, a simply comment saying 'put the points in circular order' in the help of rhinoscript would not let me have this problem... it's taking a life to learn rhinoscript this way.

    Thank you!

  • 2. Hanno (Aug 26, 2010 17.42):

    Hi Xavido,

    have a look at this thread:

    www.rhinoscript.org/forum/1/115

    I guess it's the same problem. If you input the points in wrong order, Rhinoscript corrects them most of the times but sometimes doesn't, depending on the concrete geometry of each surface.

    Hanno

  • 1. xavido (Aug 24, 2010 10.55):

    I got a problem creating surfaces with rhino. I've created a loop that creates surfaces between lines and if you look at the picture attached you will notice that some surfaces are created wrong, crossed actually.

    The code is a loop, then it's supposed to create all the surfaces equally and the error doesn't follow a patron so I don't know how to fix it.

    Any ideas? Thanks!

Recommend

Why are these buttons gray?